The template allows you to draw wires connecting your captured schematic with the lines on the virtual myDAQ device, the same way you would connect your breadboard circuit to the actual myDAQ device.Īlso, Multisim integrates NI Elvismx instrumentation within this template, allowing the users to simulate their schematic capture using familiar interfaces. These will represent the actual panels or slots that are available on myDAQ. The template, once open, will have two connecting slots: the myDAQ right slot and the myDAQ bottom terminals. (Multisim needs to be installed prior to the installation of the DAQmx software) Troubleshooting: If you can’t find the template, reinstall DAQmx.

This can be found in Multisim main toolbar at File>New>NI myDAQ Designįigure 1: Launching the NI myDAQ Design Template You can access myDAQ instrumentation in Multisim by opening the “NI myDAQ Design” template. The exercises also require the use of a breadboard, a capacitor (.1uF), a resistor (1kohm), and wires. The user should have all the components installed in this specific order: LabVIEW, Circuit Design Suite, DAQmx. Also, this document requires the installation of the myDAQ Software Suite. In the situation that you do not have this feature you must create a new component for layout only to completely replace the component in the schematic.To replicate the exercises in this document, the user needs to have myDAQ plugged in. Note: The Spreadsheet View is not available in all versions/tiers of Multisim/Multicap. In the newer version of Multisim 14.0, you would see the word Package instead of Footprint. The footprint or package is now associated with this virtual component. Pick the appropriate footprint or package for the virtual component from your database.In the Edit Footprint or Package dialog box click the Select From Database button:.When your virtual component is selected, click on it's Footprint or Package field:.Scroll over to the Footprint or Package column.Select the Component tab in the Spreadsheet View.Turn on the Spreadsheet View by selecting View»Spreadsheet View.This is not a change that can be saved to a database, and therefore you will need to repeat the following steps for each instance of the component: The footprint or package assigned to the virtual component is only valid for the symbol that is placed upon the schematic. It is possible, however, to assign a footprint or a package to your virtual components so that they can be transferred to a full PCB design.

Therefore, the component does not have a natural footprint or a package. This is because virtual components are modeled theoretically rather than as a real device that can be purchased. In Multisim, virtual components do not automatically have a footprint or a package associated with them.

Arduino in multisim